[ Chinese wardrobe net ] The wooden wardrobe is the most used in us, the most common, mainly because it is very environmentally friendly and has been used for a long time. In many cases, the wooden wardrobes we buy need to be installed by ourselves. How do you assemble wooden wardrobes? Let's take a look at the wooden wardrobe assembly method with Xiaobian.

Install from the side of the wall

Place the wide side panel on the ground to see if the hole spacing on the board matches the position on the drawing sheet. Then install the three-in-one single-link, nail the solid layer to the cork and fix it on the wide side. Above the board, the top handle has a large handle hole facing upwards, the remaining solid layers are facing downwards, and the foot line large handle holes are facing inward.

Nail back plate

Firstly, the assembled whole wardrobe side is placed on the pre-laid cloth, and the side panels of the wooden wardrobe are flattened to be in the same plane. Measure with a ruler and measure the diagonal dimensions of the cabinet to the same level. Then install the first backing plate from the wide side panel. Note that if there is a fixed layer of nails in the middle of the wooden wardrobe, it is best to mark the center line of the fixed layer with a pencil and then nail the nail.

L frame installation

First, use the side plates of the L frame to form a parallel line on the corresponding side plate, then move the 9mm to draw the center line of the three-in-one rubber. Use the bottom plate of the L frame to draw a parallel line on the corresponding bottom plate. Into the 9mm draw the center line of three one rubber particles. The hole was drilled with a 10 mm drill bit and the hole depth was 10-20 mm. Install a single pole. After the L frame is installed, nails are fixed on the back plate.

Installing the wardrobe glove rack

To be completed by two people, stand on the left and right sides of the closet, and lift the wardrobe up a little later. Firmly lift the closet and move it backwards, taking care not to scratch the floor and walls. Place the three-in-one rubber pellets into the drawer holes of the closet; connect the side panels on both sides to the draw layer.

Install three-section rails and push-pull mirrors

When installing these three sections of track, firstly, the track should be placed against the drawer of the wardrobe, flush with the floor of the drawer, and the moving mother rail fixing sub-rail screw is mounted on the vertical eye of the sub-track. After the drawer is installed, the drawer is leveled and the gap around it is even. Finally, a fixing screw is attached to the horizontal eye of the sub-track and the vertical eye of the female rail.

Well, the method of assembling the wooden wardrobe is also finished, I believe everyone is very clear. Usually there are after-sales personnel to install, but if you need to install it yourself, then the small-edit method will come in handy. Therefore, it is not a disadvantage to know more about related knowledge. If you want to know more about home, please stay tuned.

Christmas Decoration

Christmas Decoration,Xmas Wall Decorations,Christmas Ornaments,Christmas Wall Hanging Decorations

Wuyi County Yunshuo Industry and Trade Co., Ltd. , https://www.yunshuotents.com