1. Liquid sample.

The first sample was taken with the test sample and the inlet was injected into the anode chamber of the cell. It is important to note that before the sample should be cleaned with filter paper, when the cell is injected, the liquid enters the pipette and the electrolyte reagent should be inserted. Do not touch the cell wall and the electrode.

2. Solid sample.

The solid sample can be in the form of a powder, granule or agglomerate. So there will be insoluble reagent samples, then you need to choose a suitable water evaporator to connect to the instrument. The solid sampler is dry-cleaned, loaded with sample, weighed, removed from the cell's injection port cock, and inserted into the syringe injection port. Add a solid sampler to rotate the sample 180 degrees and the sample is reagent until the determination is complete. Attention to the transfer of the solid sample into the reagent cannot contact the electrolysis electrode and the measurement electrode.

3. Gas sample.

Since the moisture in the gas cannot be absorbed by the reagents, you need to use a control pattern to inject the cell connector at any time.

The gas sample for moisture determination is injected with a certain amount of reagent to ensure sufficient absorption of moisture in the gas. At the same time, the gas velocity should be controlled at about 500 ml/min. If the reagent is significantly reduced during the measurement, about 20 ml should be Inject glycol supplements (analytes can also be added to other chemicals as needed).

White Single Window Envelope

White Single Window Envelope,Commercial Single Window Envelope,Check Single Window Envelope,Business Single Window Envelope

Sun Kee Envelopes Limited , https://www.sunkeeenvelope.com