The installation of the printing plate must conform to the specifications of the stencil, and the proper backing paper can be used to print the prints that are faithful to the original. However, how to correctly and quickly calibrate the printing plate is an essential technique for an introductory technician. Thanks to the blessing of printing technology today, after the successful development of the cross gauge punching device, the previous set of printing plates has to take more than ten to twenty minutes to complete under the adjustment of skilled printing technicians. Shortened, the principle of its invention is to integrate the school-version technology that was previously considered to be the entry point for Master. It is the work of printing the four-color crosshairs of the printing plate, which is moved from the printing plate to a narrow space. To a platform puncher, the plate after punching the hole is equipped with a printer's plate clamp. The use of a printer remote control gauge device, a slight adjustment to complete the calibration is very simple, but the school board technology is also due to labor After the successful development of chemical equipment, some traditional techniques were gradually ignored by the new generation of printer technicians. Here, the school edition technology was revisited. Although it is somewhat contrary to the printing technology, the principle and the edition technology of the cylinder design are intriguing. Think of a past printer In addition to the sharp color recognition ability, it is also necessary to have both hands and feet. However, knowing that the hands and feet can be known from the speed of the school edition, this technique naturally becomes the master's skill in eating, and it must become a must for the general apprentice to get started. Important subjects. Let us discuss the principles of this school edition technology one by one!
The first thing to understand is the number of threads on the plate clamp screw, which is usually 0.75m/m, 1.0m/m, or 1.25m/when a 17 or 19 wrench is used as a calibration tool. m or 1.5m/m pitch, but the end view of the printing machine manufacturing company's lithographic design are different, the master is not printing screws indiscriminately when the master is doing printing plate correction, the master adjusts only by its feeling but how to make To be sure, it will only be a master who has been inducted after you finish reading this article (I wouldn't have studied the school before. The Master's school would be afraid to be taken away and covered with a rag.) Example 17 Wrench For 0.75m/m screws, the one-turn movement of the screw will produce a displacement of 0.75m/m. One-point rotation is 0.125m/m; two revs = 12 angles. (12take) the plate displacement of 1.5m / m to understand this design principle, pay attention to the parallel principle of the printing plate (pull the mouth three take, to remember the relative top to the right side of the three take the same principle, then reverse) as long as you will The basis of the four operations is that the calibration of each set of printing plates is calculated quickly and accurately by the brain. The school printing technology is no longer broken. After his secrets.
Careful attention to adjusting the screw angle when installing a plate
June 21 14:06:35, 2024
72/100 Pcs Drawing Color Pen,72/100 Pcs Color Dual Tip Pens,Coloring Brush Marker Pen,Felt Fine Point Tip Pens Zhoushan Shenglan Trade Co., Ltd.  , https://www.seamiart.com